Vizulize Eye Wash is for use in eyes only and can be used without having to remove contact lenses.
- Ensure your hands are clean and dry before use.
- To open the bottle, twist the cap anti-clockwise to break the seal.
- Rinse the eye bath with some eye wash before use.
- Fill the eye bath with some eye wash until it’s about a third full.
- Bend your head forward slightly, holding the eye bath by its base.
- Place the eye bath over your eye. Open your eye whilst slowly raising your head so the wash flows into it. Gently rock your head from side to side for at least 30 seconds.
- Tilt your head forward again and remove the eye bath, discarding any remaining eye wash.
- Repeat for the other eye.
Ingredients
Soft, isotonic solution containing: HPMC, Sodium Edetate 0.01%, PHMB 0.0001%.
Storage instructions:
Keep out of the sight and reach of children.
Store between 5◦C and 30◦C. Avoid direct sunlight.
Safety information:
Do not use if you are allergic to any of the ingredients.
If the eye bath will be used by more than one person, it should be sterilised between uses by boiling it in water.
Close the bottle after use.
Do not return used solution back to the bottle.
If eye irritation occurs, or the condition worsens, discontinue use and consult a healthcare professional.
Do not swallow.
Do not use after the expiry date.
Use within 30 days of first opening.
Keep out of the sight and reach of children.
Disclaimer:
All medical conditions must be diagnosed by a healthcare professional.
Vizulize Eye Wash is a medical device – always read the instructions.
